You need about 333 Wh — and 41 units fit. The smallest sufficient is the Bluetti Pioneer Na; we never push more capacity than your load can use. Surge to clear: 2,100 W.
The math
Running watts (everything on at once) = 1,000 W
Surge watts (worst single startup + the rest running) = 2,100 W
Average draw (cyclic loads counted by their duty cycle) = 150 W
Watt-hours = 150 W × 2.0 h ÷ 90% usable reserve = 333 Wh
1
Bluetti Pioneer Nasmallest that fits
900 Wh1,500 W cont · 2,250 W surge~5.4 h on this load$$$
Bluetti's first sodium-ion unit — discharges down to -25°C and charges down to -15°C, built for cold-climate outage backup where lithium units struggle.
Sodium-ion · AC; rated 4,000+ cycles over 10 years · 35 lb
1,024 Wh2,000 W cont · 3,000 W surge~6.1 h on this load$$
The 2026 redesign of the original C1000 — smaller and lighter with a bigger 2,000 W inverter and a faster 4,000-cycle battery, at roughly half the original launch price.
LiFePO4 · HyperFlash 1,600 W AC input — full charge in ~49 min · 25 lb
🔗 The "Check price" buttons are brand-direct affiliate links. We earn a commission when you buy through one — at no extra cost to you, and it never changes which unit we recommend. Disclosure.
Can a specific unit run a well pump (1/2 hp)?
41 of the units we track deliver enough watts to run a well pump (1/2 hp). Check a specific one for the runtime and the full verdict:
What size power station do I need to run a well pump (1/2 hp)?
A well pump (1/2 hp) draws about 1,000 W running, with a startup surge near 2,100 W. So you want a unit with at least 1,000 W continuous output and 2,100 W+ surge. For 2.0 h of runtime that's roughly 333 Wh of capacity — the Bluetti Pioneer Na is the smallest unit that clears all of it.
How many watts does a well pump (1/2 hp) use?
About 1,000 W while running, spiking to roughly 2,100 W on startup. It only draws power about 15% of the time, so over an outage its energy use is well below 1,000 W × the hours — which is why a modest battery lasts longer than you'd expect.
Sources: Well Pump (1/2 HP) wattage — Standard appliance-wattage / generator-sizing charts (representative values; verify your nameplate); station specs — manufacturer published specifications (compiled 2026-10-05; approximate). Informational only — a computed sizing estimate from published appliance-wattage charts and manufacturer station specs. It is not an electrical guarantee. For hardwired or whole-home backup, transfer switches, or any permanent install, consult a licensed electrician.